https://review.trustedfirmware.org/c/trusted-firmware-m/+/3960
- Queries
- All Stories
- Search
- Advanced Search
- Transactions
- Transaction Logs
Advanced Search
Apr 23 2020
Apr 22 2020
Apr 20 2020
Fix has been merged
Apr 14 2020
Apr 13 2020
Patch merged. Close it.
Apr 10 2020
I think this item is covered by other ongoing tasks, so close it.
Apr 8 2020
Apr 6 2020
Please note, this has NOT been tested with ARMCLANG, only with GNUARM. Further testing and work is required for ARMCLANG support.
Apr 2 2020
Mar 30 2020
Internal ref: https://jira.arm.com/browse/IOTPSW-2914
Internal ref : https://jira.arm.com/browse/IOTPSW-2861
Internal ref : https://jira.arm.com/browse/IOTPSW-2826
Internal ref: https://jira.arm.com/browse/IOTPSW-2801
Internal ref: https://jira.arm.com/browse/IOTPSW-2817
Mar 27 2020
Mar 26 2020
This causes random failure in PSA Arch ITS and PSA Arch PS tests.
See related Musca-A2 issue here : https://developer.trustedfirmware.org/T694
We would need to support versioning of SST FS data and also have mechanisms to detect if the flash is clean or in consistent state.
Internal ref : https://jira.arm.com/browse/IOTPSW-2808
This issue is also seen on Musca-A board.
Mar 25 2020
This is an issue on FVP. It will case the system cannot boot up after a warm reset. So as a workaround, we have to skip BL2 when testing.
The output hangs at this point :
Trying ::1... Trying 127.0.0.1... Connected to localhost. Escape character is '^]'. [INF] Starting bootloader [INF] Image 0: version=0.0.0+5, magic= good, image_ok=0x3 [INF] Image 1: No valid image [INF] Booting image from the primary slot [INF] Bootloader chainload address offset: 0x80000 [INF] Jumping to the first image slot [Sec Thread] Secure image initializing! TFM level is: 0x00000001 [Sec Thread] Jumping to non-secure code...
This is a known limitation of CC-312 and hence will not be fixed in TF-M code.
Update from Tamas
Mar 23 2020
Thanks for reminding me. Miss it. All patches had been merged, close it.
Mar 20 2020
@edison-ai , both patches were merged. Is this task done?
Mar 19 2020
Mar 12 2020
Mar 11 2020
This page lists cmake versions available in different Linux distributions.
https://gitlab.kitware.com/cmake/community/-/wikis/CMake-Versions-on-Linux-Distros
Mar 10 2020
By using this patch, the test will stop at test case 4 by the hardware flash bug, which is not related to this defect.
After the test fails, the system cannot boot up anymore except we erase the flashes again.
Mar 4 2020
Change for this issue is: https://review.trustedfirmware.org/c/trusted-firmware-m/+/3592
Mar 3 2020
Patch made to fix:
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3588
Feb 23 2020
Enable memory protection for PSA FF test: https://review.trustedfirmware.org/c/trusted-firmware-m/+/3526
Isolation level 2 peripheral MPU config:
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3524
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3525
Feb 22 2020
NSPE parameter checking of iovecs, With also checking all missed patch. These missed patched are used to take https://www.ukbestessay.net/assignment-writing look, When you decided to check all the mention informative material you understand how and in which way it important to share.
Switch SST FS from flash to RAM: https://review.trustedfirmware.org/c/trusted-firmware-m/+/3523
Feb 21 2020
Fix the isolation level issue related with ACK test
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3516
Feb 19 2020
Add lifecycle API
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3465/1
Fix the PROGRAMMER ERROR issue
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3464
Feb 18 2020
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3886
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3887
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3433
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3514
https://review.trustedfirmware.org/c/trusted-firmware-m/+/3888
Feb 14 2020
All patches had been merged into the master branch.
Feb 13 2020
Feb 12 2020
Hi Andrej,
Hi Ken,
Yes, the final patch has fixed the issue.
It works now without our workarounds.
Hi Andrej,
I have updated patch and test with FP enabled in my side and it works. Can you take a try on your side?
Thanks.
Feb 11 2020
Thanks. I just found the patch missed something, I will re-create a patch to update that.